The host bus adapter HBA and its device driver were installed automatically. Click Continue to go to the Select fixes page. Click the following link to access the PDF in a new browser window: In the Product selector field, type in Tape device drivers. The server is powered on.
|Date Added:||12 September 2009|
|File Size:||28.39 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Downloadable files Abstract Drive firmware only – there is no other updatable firmware in this product.
LED indicator for drive power status. There are a few pull down menus to navigate to the correct download as follows: The tape drives in the library are powered on. An easier way to obtain information about a drive error is to determine which drive is reporting an error, then access the error log for that drive by using the operator panel or by using the Tape Library Specialist web interface.
Downloading the IBM Tape Diagnostic Tool
These firmware updates are intended to, among other things, increase overall reliability, improve tape handling, further reduce any possibility of data errors, and provide continued enhancements to diagnostic capabilities. From the Select from Tape systems menu, select Tape drivers and software.
The Unload button on the drive was pushed in and did not release. In order to provide maximum performance and reliability, it is recommended that the latest version of microcode is installed on your IBM LTO tape devices. Use this table only if no sense data is available. Microcode or ssi drive problem. Supported Operating Environments This tape drive works sccsi the following operating systems: Tape drive detected that the Drive Power Supply is approaching the specified voltage limit drive is still operating or is outside the specified voltage range drive is not operating.
Explanation of drive code naming convention: Occasionally this LED can be blue, which does not indicate an error.
Drivers for IBM devices
Select ” Tape Drive”. The rear panel of LTO 5 and later tape drives has a power beacon LED that indicates the drive is powered on when green.
Before you install the tape device driver, ensure that the following tasks are completed: Document information More support for: You can access a drive error log from the operator panel by using the Service and Drive Error Logs menus.
Click Continue to go to the Select fixes page, view the list of available downloads. For the most recent tape drive for Windows, see Required software. In the Product selector field, type in Tape device drivers. Tape drive or RS error. LED indicator for library communications. No error or message is assigned. Select a download from the options presented, and click Continue.
From the Platform menu, select your operating system. The server is powered on. The tape drive and HBA are connected. Tape drive or media error. View the list of available downloads. This section lists error codes that can appear on the single-character display SCD of the LTO tape drives and describes each error.
Drivers for IBM devices
LED indicator for drive status. Tape drive determined that an error occurred, but it cannot isolate the error due to faulty hardware or to the tape cartridge. LED indicator for Port 0.