I don’t think it’s the hard disk. I changed my sig to represent the new power supply. It was working fine last night when I turned it on but when I went to boot it up this morning I had this problem. I am starting to think that maybe I should just get it turned on once and then leave it on for the rest of eternity. I kind of want to switch down to a lower wattage power supply since my comp is really very pretty basic and all the extra cables muck up my airflow.
|Date Added:||7 May 2014|
|File Size:||66.66 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Such as a low “gear noise”?
What can Windows tell you about the error? Hitting TAB didn’t seem to do anything, not sure if I held it down though. K9,m-v so let me know if I ,si to tell you anything else. I managed to get into BIOS setup you k9mm- to hit del at just the exact right second and turn of that darn splash screen. And seriously, what memory is that testing? This is the first I found, haven’t tested: I can get Windows up and running in safe mode but that is all I can do. It goes through each and ever part of the memory matrix.
Any advice on how to proceed would be much appreciated. Also, every now and again it will still hang at the same spot it’s been hanging. Now it gets to the XP startup screen but when it gets to the point where that’s done, the screen goes blank and my system restarts. I don’t think it’s the hard disk.
Support For K9MM-V | Motherboard – The world leader in motherboard design | MSI USA
I’ve never seen a problem like this so I will thank you all in advance for your help. I kind of want to switch down to a lower wattage power supply since my comp is really very pretty basic and all the extra cables muck up my airflow.
Could the thermal compound have broken down or djsplay You can remove full screen Logo by pressing “TAB” seconds after turn on PC, and see what is written on the screen when hang.
But I am happy you left the Ultra. It was working fine last night when I turned it on but when I went to boot it up this morning I had this problem. Cost more than the motherboard and, as I said, I checked the voltages it put out and they were fine. I am not really a hardware guy or a software guy for that matter: So what can I do short of replacing the motherboard that might fix this? How do I check the CPU cooling system?
Microstar (MSI) K9MM-V VGA Driver v6.14
It just hangs on that first screen. But if it was my video card, I wouldn’t get any display, right? In fact, it is the o9mm-v same result if I have no drives plugged in at all. And I checked the CPU temperature as well and it’s actually running very cool so I don’t think it’s that either.
The two things I did not think to try were popping out the little battery to clear the CMOS and unplugging my video card and using the onboard chip set. We have had numerous issues with the brand. As far as power supply smi, I checked out the voltages in the BIOS setup and they were reasonable.
Now you have a better shot at getting a well working system.
I changed my sig to represent the new power supply. A Repair k9mm-g of Windows, with minimum hard ware, is something else to try. What memory, exactly, is it testing on the “Memory Testing” line anyway? I am starting to think that maybe I should just get it turned on once and then leave it on for the rest of eternity. Please login or register. There is a program called memtest